AEROFLEX-IFR FM/AM-500A CALIBRATION and AEROFLEX-IFR FM/AM-500A REPAIR
 
A calibration by Custom-Cal is performed by engineers with extensive OEM experience. We have the expertise and the necessary standards to perform the AEROFLEX-IFR FM/AM-500A Calibration, onsite calibration may be available. We specialize in quick turnaround times and we can handle expedited deliveries upon request.

Need another Communication Analyzer?
Shop for Comparable Products on our  used Communication Analyzer page or new Communication Analyzer page

 
   AEROFLEX-IFR FM/AM-500A (500A)   Description / Specification:    
AEROFLEX-IFR FM/AM-500A Communications Service Monitor

The IFR-Aeroflex FM/AM-500A Communications Service Monitor is the perfect test solution for a wide range of wireless communication test requirements. Typical applications include FM/AM testing, conventional two-way radio test, SSB testing and basic communication systems performance tests. Standard Features. FM and AM Signal Generator. 2 uV receiver for AM, FM and SSB. 10 Hz to 9999.9 Hz variable audio generator and audio frequency error meter. 1 kHz audio generator. Frequency error meter with 1 Hz resolution. Peak/Average watt meter. Deviation measurement to 60 kHz. SINAD/ Distortion Meter. 0.2 ppm TCXO. Microphone input. Audio demodulator output. Specifications. RF Signal Generator Frequency Range: 250 kHz to 999.9999 MHz. Resolution: 100 Hz. Variable Generate: Continuous tuning ± 10 kHz from selected frequency. Residual FM: < 100 Hz peak RMS. RF Output Power: -127 dBm to -20 dBm (10 dB steps with 11 dB range continuous vernier). RF Output Accuracy: ± 3 dB. Audio Generator Operating Modes: Internal, Speaker, External + Internal. Tone Output Level: 0 to 2.5 VRMS into 150 ohm load. Frequency Range: 10 Hz to 9999.9 Hz in 0.1 Hz increments. Generate Amplifier Gain: 30 dB ± 2 dB typical, 100 kHz to 1000 MHz. Power Meter Range: 0 to 15 and 0 to 150 W peak or average responding. Receiver Monitor Frequency Range: 100 kHz to 999.9999 MHz in 100 Hz increments. Sensitivity: 2 uV (1 MHz to 1000 MHz, FM Narrow).



 

Standard Calibration $805.00 *
Click on Logo for More Prices
*This is a Web introductory price for one calibration of the AEROFLEX-IFR FM/AM-500A. Price does not in most cases include measurement performance data. Pricing does include NIST traceable calibration and issue of a calibration certificate and calibration label. Pricing may vary slightly due to volume and location of laboratory supporting calibration. Volume pricing may apply. On-site fees may apply depending on logistics, location and volume of work to be completed during the visit.


Related Communication Terms and Definitions. For a complete list go to our  Terms and Definitions Page.

Bandwidth
Bandwidth is the difference between the upper and lower frequencies in a contiguous set of frequencies within which a fiber optic component, link or network will operate.

Multimode Fiber
Multimode Fiber has a large core (almost always 62.5 microns - a micron is one one millionth of a meter - but sometimes 50 microns) and is used with LED sources at wavelengths of 850 and 1300 nm for short distance, lower speed networks like LANs. Both multimode and singlemode fiber have an outside diameter of 125 microns - about 5 thousandths of an inch - just slightly larger than a human hair.

SDH
Synchronous Digital Hierarchy (SDH) is an international digital telecommunications network hierarchy which standardises transmission around the bit rate of 51.84 megabits per second, which is also called STS-1. Multiples of this bit rate comprise higher bit rate streams. Thus STS-3 is 3 times STS-1, STS-12 is 12 times STS-1, and so on. STS-3 is the lowest bit rate expected to carry ATM traffic, and is also referred to as STM-1 (Synchronous Transport Module-Level 1). The SDH specifies how payload data is framed and transported synchronously across optical fibre transmission links without requiring all the links and nodes to have the same synchronized clock for data transmission and recovery.

Please contact us for your AEROFLEX-IFR FM/AM-500A CALIBRATION and/or AEROFLEX-IFR FM/AM-500A Communications Service Monitor REPAIR
I'm interested in: 
Calibration Type (Select one):
Repair Information:
 Serial Number:

 Is there any physical damage?  
 If yes, describe:


What is the description of the problem?

How/when did the problem start?


 (*) Required Fields    For formal quote please fill in all fields.
Company:
From (Email):*
Contact Name:*
Country:*
Address 1:
Address 2:
City:
State/Territory/Province: *
Zip/Postal Code:
Phone:*

Comment: