KEYSIGHT N5234B CALIBRATION and KEYSIGHT N5234B REPAIR
 
A calibration by Custom-Cal is performed by engineers with extensive OEM experience. We have the expertise and the necessary standards to perform the KEYSIGHT N5234B Calibration, onsite calibration may be available. We specialize in quick turnaround times and we can handle expedited deliveries upon request.

Need another Network Analyzer, SNA, VNA?
Shop for Comparable Products on our  used Network Analyzer, SNA, VNA page or new Network Analyzer, SNA, VNA page

 
   KEYSIGHT N5234B   Description / Specification:    
KEYSIGHT N5234B 43.5 GHz PNA-L Microwave Network Analyzer

The Keysight N5234B PNA-L Microwave Network Analyzer, 10 MHz to 43.5 GHz, 2-ports with a single built-in source. It can perform basic analysis of passive components and simple active devices. Measure S-parameters with good accuracy up to 43.5 GHz.
Specifications.

Maximum System Dynamic Range: 132 dB (8.5 GHz to 12.5 GHz, Option 216, Direct Receiver Access port).
Maximum Receiver Dynamic Range: 129 dB (8.5 GHz to 13.5 GHz).
Test Ports: 2.4 mm (male), 50 ohm, (nominal), 0.002 in. (characteristic).

Test Port Output.
Frequency Range: 10 MHz to 43.5 GHz.
Frequency Resolution: 1 Hz.
Frequency Accuracy: +/- 1 ppm.
Frequency Stability Typical: +/-0.05 ppm, -10° to 70° C.
Maximum Leveled Power: 6 dBm (8 GHz to 12.5 GHz, Option 200).

Test Port Input.
Maximum Test Port Noise Floor: -128 dBm (2 GHz to 13.51 GHz, Option 216, Direct Receiver Access port).

Hardware options.
N5234B-200  2-port base hardware configuration.
N5234B-216  2-port, configurable test set, source attenuators.

Software Options with Subscription.
S93007B  Automatic fixture removal.
S93010B  Time-domain analysis.
S93011B  Enhanced time domain analysis with TDR.
S93080B  Frequency-offset measurements.
S93082B  Scalar mixer/converter measurements.
S94601B  Device measurement eXpert - DMX.
S94602B  Limit assistant.
S930900B  Spectrum analysis up to 8.5 GHz.
S930901B  Spectrum analysis up to 13.5 GHz.
S930902B  Spectrum analysis up to 26.5 GHz.
S930904B  Spectrum analysis up to 43.5 GHz.
S93551B  N-port measurements.
S93898B  Built-in performance test software.



 



Related RF Terms and Definitions. For a complete list go to our  Terms and Definitions Page.

dBc
dBc (decibels relative to the carrier) is the power ratio of a signal to a carrier signal, expressed in decibels. If the dBc figure is positive, then the relative signal strength is greater than the carrier signal strength. If the dBc figure is negative, then the relative signal strength is less than carrier signal strength.

Noise Density
Noise Density is the amount of noise within a defined bandwidth, usually normalized to 1 Hz.

Spurious Signals
Spurious signals are undesired signals. They can be considered in two classes. They can be stationary; their frequency and amplitude do not change significantly, or non-stationary, where the frequency and/or amplitude change significantly over short time periods.

Please contact us for your KEYSIGHT N5234B CALIBRATION and/or KEYSIGHT N5234B 43.5 GHz PNA-L Microwave Network Analyzer REPAIR
I'm interested in: 
Calibration Type (Select one):
Repair Information:
 Serial Number:

 Is there any physical damage?  
 If yes, describe:


What is the description of the problem?

How/when did the problem start?


 (*) Required Fields    For formal quote please fill in all fields.
Company:
From (Email):*
Contact Name:*
Country:*
Address 1:
Address 2:
City:
State/Territory/Province: *
Zip/Postal Code:
Phone:*

Comment: