A calibration by Custom-Cal is performed by engineers with extensive OEM experience. We have the expertise and the necessary standards to perform the BOONTON 51033(6E) Calibration, onsite calibration may be available. We specialize in quick turnaround times and we can handle expedited deliveries upon request.

Need another RF Power Sensor?
Shop for Comparable Products on our
 used RF Power Sensor page

   BOONTON 51033(6E) (51033-6E)   Description / Specification:   Spec Sheet 
BOONTON 51033(6E) 18 GHz Dual Diode Sensor

The Boonton 51033(6E) Dual Diode Sensor is constructed using balanced diode detectors. This dual diode configuration offers increased sensitivity and harmonic suppression when compared to a single diode sensor. For use with Models 4731, 4732, 4231A, 4232A, 4300, 4531, 4532, 5231, 5232, 5731, 5732. Specifications. Frequency Range: 100 kHz to 18 GHz. Dynamic Range: -40 to +33 dBm. Overload Rating Pulse: 10 W for 1┬Ás. Overload Rating Continuous: 2 W. Maximum SWR: 100 kHz to 1 GHz, 1.07; 1 GHz to 2 GHz, 1.10; 2 to 4 GHz, 1.12; 4 to 12.4 GHz, 1.18; 12.4 to 18 GHz, 1.28. Impedance: 50 ohm. RF Connector: Type N (M).


Standard Calibration $265.00 *
Click on Logo for More Prices
*This is a Web introductory price for one calibration of the BOONTON 51033(6E). Price does not in most cases include measurement performance data. Pricing does include NIST traceable calibration and issue of a calibration certificate and calibration label. Pricing may vary slightly due to volume and location of laboratory supporting calibration. Volume pricing may apply. On-site fees may apply depending on logistics, location and volume of work to be completed during the visit.

Related RF Terms and Definitions. For a complete list go to our  Terms and Definitions Page.

dBc (decibels relative to the carrier) is the power ratio of a signal to a carrier signal, expressed in decibels. If the dBc figure is positive, then the relative signal strength is greater than the carrier signal strength. If the dBc figure is negative, then the relative signal strength is less than carrier signal strength.

Noise Density
Noise Density is the amount of noise within a defined bandwidth, usually normalized to 1 Hz.

Spurious Signals
Spurious signals are undesired signals. They can be considered in two classes. They can be stationary; their frequency and amplitude do not change significantly, or non-stationary, where the frequency and/or amplitude change significantly over short time periods.

Please contact us for your BOONTON 51033(6E) CALIBRATION and/or BOONTON 51033(6E) 18 GHz Dual Diode Sensor REPAIR

I'm interested in: 
Calibration Type (Select one):

Repair Information:
 Serial Number:

 Is there any physical damage?  
 If yes, describe:

What is the description of the problem?

How/when did the problem start?

 (*) Required Fields    For formal quote please fill in all fields.
From (Email):*
Contact Name:*
Address 1:
Address 2:
State/Territory/Province: *
Zip/Postal Code: